In preparation for our Bahamian cruise this winter we have spent
the last month and a half working on “No Worries”, our 1977 Allied Seawind
II. Although still running (most of the
time) it was time to retire the slow 34-year old engine. We decided to go big, upgrading from a 25 hp
to a 38 hp, which although more powerful is actually smaller than the old
beast!
Just to get to the engine required taking the sink out, then
cutting away the bulk head, opening up the first can of worms of which there
would be many throughout the whole project.
Moving the 450lb engine out of the engine compartment was actually one
of the easiest parts of the job, the two of us managed to use physics, a plank
and some pulleys and the job was done.
Next came pulling out the fuel tank, this was also built into the boat
so this was our one opportunity to pull it out and inspect it. Luckily the inside was extremely clean and
didn’t show any signs of degradation, to keep it that way we coated it in
fiberglass. Of course this had to be
done inside the cabin since the tank would not fit out the campionway, fun
stuff since it barely fit in the cabin either.
With the engine out we cleaned the bilge, finding every
piece of hardware, tools, and random unidentifiable bits that have been dropped
over the life of the boat, all coated in a greasy mess. Channing spent days upon days rebuilding the
engine mounts, changing out fuel lines, exhaust fittings and everything else
imaginable. In the mean time I went to town
painting, varnishing, shining and cleaning everything else.
With the new engine in place and aligned (another multi-day
project) she fired up beautifully on the first try. We tied up the loose ends and got her back in
the water ASAP. We are not back to 100%
yet, but as I write this we are sitting at anchor waiting for the tide to come
in to get “No Worries” back to her slip in Bokeelia. We plan to finish up the last of the projects
over the next week and then we are off.
Hopefully the beautiful weather we are having will hold!!
No comments:
Post a Comment